Server for DD Language

[AndreyVN]

Hi everyone,

What kind of OPC/DDE server may I use for communicate SCADA system (RS View 32) with FF device?

As I’m guess the server must be configured with DD language?

Thanks.

Best regards.
Andrey.

[flaviostz]

Hi everyone,

What kind of OPC/DDE server may I use for communicate SCADA system (RS View 32) with FF device?

As I’m guess the server must be configured with DD language?

Thanks.

Best regards.
Andrey.
Many FF systems are OPC compatible, therefore if RSView32 is an OPC client, you can connect them.

For example, Smar System302 has a linking device called DFI302 along with OPC Server. See more information at:

http://www.smar.com/system302/index.asp
https://www.smar.com/products/dfi302.asp

A few questions:
- What is the host system that this device is connected?
- What kind of connection your Scada System allow? OPC?

Cheers!
Flávio.

[AndreyVN]

Hi Flávio, thanks for replay!

- What kind of connection your Scada System allow? OPC?
OPC, DDE, Ethernet/IP drivers and direct connection via RS232 to some models of PLC.

- What is the host system that this device is connected?
I wish to connect Scada to Endress+Hausser devices: temperature sensor RTD-TR10, radar-level Micropilot-M.These devices have FF, modbus and HART protocol.

For make this connection I see the following:
1) Buy E+H program, which collect and visualize data like Scada. This is too expensive for us.
2) Make (I am programming on C++ language) DDE server based on low-level modbus protocol. This is too long time.
3) Find and buy OPC/DDE server and configure it with DD language.

Best regards.
Andrey.