Alert after FF device powered on

[lhubka]

Hallo, is there a special alert which would inform me that the device have been powered on? Thanks. I have already posted a very similar and much more detailed question about the same topic, but it is still not visible in the thread list.

[HetzEH]

There is at least one alarm i know: FF-890 FS 1.9; Page 78-79; Figure 21. Please take a closer look at Resource State Start/Restart :"...After successfully init.... resource block should generate a block alarm with the subcode set to "Power-up"......".

[lhubka]

Hallo. Thank you for the reply. But it doesn't work - when I disconnect the device from the Bus and after a while connect it back again I got only an update event from the transducer block. But if the device has no transducer block, there is no alert at all. The block alarm with "Power up" I get only when I set the FB to OOS and then back to Auto/Manual.